Alloy: N06040
Select a Cast Grade
or Select a Wrought Grade
or Select Cast UNS From the Following Categories
or Select a Wrought Grade
or Select Cast UNS From the Following Categories
MT Grade: MTEK CY-40
Similar Specifications
Cast UNS: N06040
Cast Grade: CY-40
Cast ASTM: A494
Wrought UNS: N06600
Wrought Grade: INCONEL® 600
Typical Chemical Composition (% by wt.)
C Max: 0.40
Cr: 14-17
Ni: BAL
Mn: 1.50
Si: 3.00
Other: Fe 11.0 MAX
Minimum Mechanical Properties
Tensile, ksi: 70
Tensile, MPa: 485
Yield, ksi: 28
Yield, MPa: 195
Elongation %: 30
Heat Treatment: SOL. ANNEAL
Inconel® trademark of Special Metals
Disclaimer: The data and information here are believed to be reliable. However, this material is not intended as a substitute for competent professional engineering assistance which is a requisite to any specific application. MetalTek International , its companies or businesses, makes no warranty and assumes no legal liability or responsibility for results to be obtained in any particular situation, and shall not be liable for any direct, indirect, special or consequential damages therefrom. This material is subject to revision without prior notice.
