MetalTek International

Corporate Headquarters  262-544-7777    Corporate Sales  262-650-7171

MetalTek International helps customers solve their metals challenges in heat, wear, and corrosion - WORLDWIDE

Ask The Metal Experts

 

Ask the Metals Experts

 

Alloy: NITRONIC® 40

Select a Cast Grade

or Select a Wrought Grade

or Select Cast UNS From the Following Categories

MT Grade: NITRONIC® 40

Similar Specifications
Wrought UNS: S21900
Wrought Grade: NITRONIC® 40

Typical Chemical Composition (% by wt.)
C Max: 0.08
Cr: 19.0-21.5
Ni: 5.5-7.5
Mn: 8-10
Si: 1.00
Other: N 0.15-0.40

Minimum Mechanical Properties
Tensile, ksi: 90
Tensile, MPa: 620
Yield, ksi: 48
Yield, MPa: 330
Elongation %: 35
Brinell Typical: 185
Heat Treatment: SOL. ANNEAL



Produced under license of ARMCO Advanced Materials Corp.

Disclaimer: The data and information here are believed to be reliable. However, this material is not intended as a substitute for competent professional engineering assistance which is a requisite to any specific application. MetalTek International , its companies or businesses, makes no warranty and assumes no legal liability or responsibility for results to be obtained in any particular situation, and shall not be liable for any direct, indirect, special or consequential damages therefrom. This material is subject to revision without prior notice.

Compliance: Products MetalTek International manufactures are in compliance with Section 1502 of the Dodd-Frank Act pertaining to conflict minerals.

©2014 MetalTek International. All rights reserved.     Industrial Marketing by Top Floor Technologies
Site Map